
An electric bus air conditioner may list both cooling and heating capacities, but heating is not necessarily included as standard. TCHAIN’s TCD/TD series has a cooling-only base configuration, with heating available as a specified option.

The TCHAIN catalogue lists five models in its electric bus air-conditioning range: TCD07A, TCD07D, TCD08D, TD40A and TCD12D. The base configuration for each is cooling-only. Heating is optional, and the rated heating capacities shown in the catalogue apply to heating-enabled configurations, not automatically to every unit of that model.
This distinction matters when comparing quotations. Two offers may name the same model and cooling capacity but specify different equipment. To make the comparison meaningful, the required configuration should be stated explicitly.
The catalogue lists the following configurations across the TCD/TD series:
The options available vary by model. TCD08D and TCD12D list seven configurations, while TD40A lists two: cooling, and heat pump + PTC. TCD07A and TCD07D have fewer listed options.
The catalogue identifies the configurations but does not rank them by efficiency or recommend one for a particular operating condition. The appropriate option should be confirmed for the vehicle and application.
For TCHAIN’s diesel bus air conditioners (TCH series) and built-in units (TCN/TC series), the catalogue tables list rated cooling capacity only. Heating availability for these ranges should be confirmed with the supplier for the specific model.

The catalogue lists the following rated heating capacities for the electric bus range:

These are rated figures. The catalogue notes that configurations, parameters and applicable bus lengths may vary according to region and customer requirements. Confirm the final specification with the supplier before ordering.
The catalogue’s application information shows that vehicle length recommendations can vary by region. For example, TCD07A is listed for buses measuring 6.0–7.0 m in southern regions or 7.0–8.0 m in northern regions. TCD07D is listed for 6.5–7.5 m in southern regions or 7.5–8.5 m in northern regions.
Climate should therefore be considered alongside bus length and voltage. A fleet operating mainly in warm conditions may not require heating. A fleet exposed to cold seasons should specify its heating requirements before finalising the system.
Four details can affect the suitable model and configuration:
Suppliers should quote against the same information so that offers can be compared on a like-for-like basis. This also avoids assuming that a heating capacity listed in a parameter table is included in the base unit.

Before finalising a specification, provide the supplier with the bus length, on-board voltage, operating climate and heating requirement. Confirm the applicable model, exact configuration, and rated cooling and heating capacities.
For diesel or built-in models, heating availability should be checked for the specific model rather than inferred from the catalogue’s cooling-capacity table. Configurations and parameters should be confirmed by both parties.
Does an electric bus air conditioner include heating as standard?
No. In TCHAIN’s TCD/TD range, cooling is the base configuration. Heating is specified separately, and the listed heating capacity applies to heating-enabled versions.
What does “cooling-only” mean?
It means the unit is specified in the catalogue’s “Cooling” configuration, without a listed heating option. Cooling is available as a configuration across the five models in the electric range.
Which heating options are listed?
The catalogue lists PTC, heat pump + PTC, and plate-type heat exchanger configurations, including combinations with an expansion tank and water pump. Availability varies by model.
What is the rated heating capacity?
The catalogue lists 12,000 kcal/h for TCD07A, 14,000 kcal/h for TCD07D, 20,000 kcal/h for TCD08D, 26,000 kcal/h for TD40A and 30,000 kcal/h for TCD12D.
Do diesel and built-in bus air conditioners include heating?
The TCH diesel and TCN/TC built-in parameter tables list rated cooling capacity. Heating availability for these ranges should be confirmed for the specific model.
What information is needed for a cold-climate specification?
Provide the bus length, on-board voltage, operating climate and heating requirement, and specify the exact heating configuration. Confirm the model and rated capacities before finalising the order.




